Kiss FC Dimensions

[Rydogdav]

Hey all! I'm planning on 3D printing my own chassis for my first homemade quad-copter, the UAQV-1. I'm working on CADing out the chassis, but I can't seem to find the Kiss FC dimensions. I don't have the money to purchase all of my components right now, and am going to wait until I can purchase all of my parts at once, so for those how are experienced with this flight controller, or own one, what are the dimensions of the chip?
Thanks! Rydogdav

 

[Snarls]

Hi Rydogdav welcome to the forum! Check out page 6 of the KISS FC manual: https://flyduino.net/ultraesc/downloads/Flyduino-KISS-FlightController-Manual-v1.06-en.pdf

The KISS FC uses standard 30mm x 30mm mounting holes so that is what you will be most concerned about.

Looking forward to seeing your chassis design!

 

[PsyBorg]

Be careful if you have an early one though. My first one was not quite the standard 30 x 30 mm and the holes had to be opened up a little bit to avoid snapping the plastic stand offs. They even had that noted in the first RR 5 alien build. Think they were actually a half a mm of on each corner.

 

[Rydogdav]

The KISS FC uses standard 30mm x 30mm mounting holes so that is what you will be most concerned about.

Thank you very much. I had read that, but it didn't really click what that meant (thought that had something to do with the size of the mounting holes).

 

[JimCR120]

Welcome to the forum.

Are where in the world do you fly? How long have you been in the hobby?
—Jim

 

[Rydogdav]

Thanks, Jim. I'm for Dallas, Texas and I'm just starting the hobby.