More laminating...
View attachment 182025
Gluing together a pair of spars to form the leading edge - aligned so they curve into each other and should be pretty straight when dried this way.
View attachment 182027
Laminations dried up, time to start laying out the wing
View attachment 182026
Sanding the laminations flat - spray adhesive holding a full sheet of sandpaper to a smooth board works great for that.
View attachment 182028
Figuring out the angle of the cuts to trim the wing tips with the 2" of dihedral per the plans.
View attachment 182029
Everything trimmed to length and angles matching up nicely
View attachment 182030
Now gluing the dihedral braces to the leading and trailing edges (yes, it is a lot taller than the trailing edge especially - that might be a lot of sanding coming up....
View attachment 182032
Put the wing tips off to the side and time to start the wing ribs and gussets. Note the gussets are not flat to the building board, but lifted up to the middle of the ribs - that's so the bottom spar that goes across the ribs can still be fit into place later. I almost missed this in the build notes...
View attachment 182031