I just finished cutting out new foam board for a mini arrow. I will be using all of the electronics from a recently destroyed tiny trainer that was using the power pack A. I weighed a sheet of the uncut foam board that I picked up at Hobby Lobby and it is ~250 grams, which is way heavier than the 112 grams of the flitetest stuff. This is especially concerning given the power pack A. I have started to remove the paper from the inside of the wings, but was wondering what areas I could remove paper from and which areas should be left alone. For example, should I remove the paper on the spars? Should I remove it from both all sides, the inside (within the C), or the outside?
On a related note, any good methods for peeling the paper. I have found that peeling very slowly does the best job at removing the paper and glue.
On a related note, any good methods for peeling the paper. I have found that peeling very slowly does the best job at removing the paper and glue.