Master series sukhoi build thread

[The Hangar]

Yeah, the VG’s will help a lot.

 

[The Hangar]

I don't have a 3d printer but would poster board work? And if so how would I set it up.

Yes, that’s what I used on the ft-3D.

 

[Grifflyer]

I don't have a 3d printer but would poster board work? And if so how would I set it up.

Yes Poster board will work, just make some triangles and glue them right behind the LE of the wing and angle them at about 35 degrees.

 

[mach1 rc]

Yes, that’s what I used on the ft-3D.

How would they go on

 

[mach1 rc]

Yes Poster board will work, just make some triangles and glue them right behind the LE of the wing and angle them at about 35 degrees.

Ok thanks should they funnel air or direct them outwards.

 

[The Hangar]

Ok thanks should they funnel air or direct them outwards.

My ft-3D has both.

 

[mach1 rc]

Hey @SquirrelTail do you know if sukhois have gforce generators?

 

[Grifflyer]

Set them up like in this image.

 

[mach1 rc]

My ft-3D has both.

Ok I'll kinda look off the 3d

 

[mach1 rc]

Set them up like in this image.
View attachment 152492

Ok thanks😁👍

 

[Grifflyer]

Hey @SquirrelTail do you know if sukhois have gforce generators?

Do you mean side force generators?

 

[mach1 rc]

Do you mean side force generators?

Yah... my bad

 

[Grifflyer]

Yah... my bad

I don't know if they have them or not but it wouldn't hurt to add them, they help a lot in knife edge.

 

[The Hangar]

I don't know if they have them or not but it wouldn't hurt to add them, they help a lot in knife edge.

Like you know anything about 3D!

 

[mach1 rc]

I don't know if they have them or not but it wouldn't hurt to add them, they help a lot in knife edge.

That could be why my eflite one needs a lot of power to hold a knife edge.

 

[Grifflyer]

Like you know anything about 3D!

I know how to make the planes fly good, just not how to fly the planes good

 

[mach1 rc]

Anyone think I'll have any problems with the propeller barely sticking out the ends.

 

[Grifflyer]

Anyone think I'll have any problems with the propeller barely sticking out the ends.

Nope, most of the thrust is created on the edges anyway, because that's where the prop is spinning the fastest. Have you seen my XF5F? The props barely stick out past the cowl and it flies fine with tons of power.

 

[mach1 rc]

Nope, most of the thrust is created on the edges anyway, because that's where the prop is spinning the fastest. Have you seen my XF5F? The props barely stick out past the cowl and it flies fine with tons of power.

Great no I haven't seen the XF5F

 

[Grifflyer]

Great no I haven't seen the XF5F

It's a goofy looking twin, https://forum.flitetest.com/index.p...-1-skyrocket-by-grifflyer-and-jimcr120.36159/