New guy here, built and finally managed to fly (without crashing ) a Tiny Trainer. One issue I have noticed is that my 3d printed firewall seemed to have gotten a bit... "melty" . Noticed that tonight when preparing to rebuild the power pod for the 7 or 8th time. (slow, stubborn learner)
The motor is obviously getting hot, I noticed that after about 7-8 minutes that I flew. Not sure how hot they are supposed to get, Im new to the hobby. But Im assuming mine was too hot. Ive lawn darted the plane a few times, but nothing other than the pod seemed damaged. Attached are the pics of my electronics, everything is supposed to be rated to work with each other.
Thoughts? I really like the 3d printed firewalls, they are quick and easy to make. I just tell my robot to make more.
The motor is obviously getting hot, I noticed that after about 7-8 minutes that I flew. Not sure how hot they are supposed to get, Im new to the hobby. But Im assuming mine was too hot. Ive lawn darted the plane a few times, but nothing other than the pod seemed damaged. Attached are the pics of my electronics, everything is supposed to be rated to work with each other.
Thoughts? I really like the 3d printed firewalls, they are quick and easy to make. I just tell my robot to make more.