Motors Spinning at Different Speeds

jaked0120

New member
I've been working on my new 250mm quad, and when I use the manual motor control in Betaflight, they all spin at the same speed. However, when I go to use the transmitter, they all spin at different speeds. I've tried calibrating the escs and that didn't work. I've included a screenshot of the problem

Hardware: Naze32, Castle 35A escs, Hobbysky 2204 2300kv brushless motors, spektrum radio system

Uneven.PNG
 

ElectriSean

Eternal Student
Mentor
This is normal when running on the bench with the props off. I would throw the props on and try a test hover.
 

Bromego

New member
What about the trim on the transmitter? Make sure that the trims are centered. I had the same problem. If that doesnt work try calibrating your transmitter stick ends too.

If this is the quad in level mode it will also decrease and increase certain motors to try and correct the quad back to level.