voipmonkey
Senior Member
Hi Guys
I need to bow down to the wealth of knowledge on here an ask for advice
I am having a few issues setting up my multi wii controller I made for my Quad.
I am following the guide on this site. http://www.multiwiicopter.com/pages/multiwiicopter-wiki
and i cant seem to get my readings to be stable. I am new to the dx8 and am wondering if i am doing something wrong.
I have setup the travel to 105% as stated and then using the sub trim menu setup each middle ground. this is ok 1 or 2 points off. i then try and go back to the max and min trying to set 1095 and 1905 but this then blows out the middle setting. What ever i try it seems to not be very stable.
I do have the nunchuck on this also and wondered if i should remove it and see if this helps? at a bit of a loss as you all can tell.
can anyone advise me on the best way forward.
thanks
Mark
I need to bow down to the wealth of knowledge on here an ask for advice
I am having a few issues setting up my multi wii controller I made for my Quad.
I am following the guide on this site. http://www.multiwiicopter.com/pages/multiwiicopter-wiki
and i cant seem to get my readings to be stable. I am new to the dx8 and am wondering if i am doing something wrong.
I have setup the travel to 105% as stated and then using the sub trim menu setup each middle ground. this is ok 1 or 2 points off. i then try and go back to the max and min trying to set 1095 and 1905 but this then blows out the middle setting. What ever i try it seems to not be very stable.
I do have the nunchuck on this also and wondered if i should remove it and see if this helps? at a bit of a loss as you all can tell.
can anyone advise me on the best way forward.
thanks
Mark