My Blackout Mini H Quad build so far..

[severed]

I'm ordering part as they because available or as money permits.

As of now I have:
Full Naze32
4- Lumenier 12A N-FET ESC
4- Lumenier 2206-11 2350KV motors
Mobius action cam for recording
3- Turnigy 2200mAh 3S batteries for my trasmitter
4- Turnigy Nano-tech 1300mAh 45c batteries
3- Lumenier LX 1300mAh 60C batteries
Radioshack buzzer
Gemfan 5x3 props
Gemfan 5x3 carbon fiber props
Lumenier 5x3 carbon fiber props
Blackout frame is ordered but on backorder

Still left to get:
FrSky Taranis X9D Plus
FrSky D4R-II 4ch 2.4Ghz Receiver
RunCam 600TVL DC 5-17V Wide Voltage Mini FPV Camera
ImmersionRC 5.8GHz 600mw
ImmersionRC EzOSD
Fat Shark goggles of some kind.

If there is something else that you can think I left out or something you think I should change, please let me know and give me a reason why.
Thanks

 

[FinalGlideAus]

I would change to a PZ0420 Super Had II board camera or a an Effio-V. The RunCam's are a bit ordinary if it's the one I'm thinking of.

Those cams are mostly 12v input. You can run it off the main battery feed but then you'll need a filter to remove the noise and you run the risk of loosing power at very low voltages which will end in a crash. The IRC VTX has a filtered power output for clean power but is only 5v out. I use this to step up the 5v to 12v and it works great.

https://www.pololu.com/product/2117

BTW: The 5030 Gemfans will fine to learn on but you will want to upgrade to HQ5x4 or HQ5x4.5 Bullnose props later on as you get used to the quad. Oh and those Carbon Fiber Gemfan props are useless sorry to say.

 

[severed]

The camera I have listed is the new "mini" version and is 5-12v. The video transmitter has a filter built in.

 

[FinalGlideAus]

Yeah but the video quality is rather poor compared to the good old faithful versions. I have a runcam at home.