Hey just wanted to put up a post on here to try an get some help trouble shooting some problems I'm having with my esc motor and combo.
I'
m looking to make a plane with some of my old unused quad equipment
I'm using a 2207 brushless motor and a 20A Bl heli esc, i have just connected the motor and esc directly to my receiver Via a PDB using the 5v and the motor power ports (as i wasn't sure if my esc had a BEC to keep the magic smoke in). Photo below
When i plug my battery in the receiver powers up fine and the esc makes the starting tones and the arming tones however (this is where it gets weird)
the motor will only begin to spin when my throttle trim is at its lowest setting and when it does spin it spins very slowly (and smoothly) and any input on my TX (pitch, roll, yaw and throttle) causes the motor to Judder pretty violently like an aggressive toothbrush but it still wont actually spin up properly it just increases the amount it judders based on how much control input it receives on either sticks.
I'm completely boggled by this and may just order a new esc Specifically for planes any help with this strange issue would be greatly appreciated
Thanks
I'
I'm using a 2207 brushless motor and a 20A Bl heli esc, i have just connected the motor and esc directly to my receiver Via a PDB using the 5v and the motor power ports (as i wasn't sure if my esc had a BEC to keep the magic smoke in). Photo below
When i plug my battery in the receiver powers up fine and the esc makes the starting tones and the arming tones however (this is where it gets weird)
the motor will only begin to spin when my throttle trim is at its lowest setting and when it does spin it spins very slowly (and smoothly) and any input on my TX (pitch, roll, yaw and throttle) causes the motor to Judder pretty violently like an aggressive toothbrush but it still wont actually spin up properly it just increases the amount it judders based on how much control input it receives on either sticks.
I'm completely boggled by this and may just order a new esc Specifically for planes any help with this strange issue would be greatly appreciated
Thanks