N00b Intro - Carbon Cub S2/DX8E

[countbob]

Hi all,

Have been flying with a Sport Cub S, then upgraded to the UMX Turbo Timber, and then decided it was time to try something bigger. Am trying to get the Carbon Cub S2 working with my DX8E controller, and I can't seem to get both flaps working AND have SAFE selection work. Anybody have a controller setup that they are sure works with both?

-Bob

 

[bisco]

welcome!

did you get them working on the timber?

 

[countbob]

It works fine on the UMX Timber. I've run across someone else who had a problem where they could not get out of SAFE mode when they had also selected the 2aileron/1flap servo setup on the Carbon Cub, and recommended just leaving it set to default. Which seems weird but I'm going to give that a try next.

 

[countbob]

That didn't work, argh. Guess I'm going to have to call Hobbyzone tomorrow to see what they say.

 

[bisco]

you can check here too, there's a DX transmitter forum and some carbon cub owners:


https://www.rcgroups.com/forums/showthread.php?1967153-Spektrum-DX6(G2-G3-e)-DX7(G2)-DX8(G2-e)-DX9-DX18G2-DX18T-DX20-Questions-and-Answers/page4781#post49474071