Helpmegetofftheground
New member
I am about to give up on this whole fpv thing because I cannot seem to get my board to connect. I have destroyed 3 boards in this process and I am sending this one out to see if someone can help me.
1. I am running windows 10
2. I have tried to load firmware via cleanflight and via a STM32 loader
3. I have purchased a new Naze32 rev 6 and as soon as I plugged it in, clean flight said I needed to update the firmware
4. I updated and power cycled
5. The board would not connect (port closed after a few seconds)
6. Connected boot pins via a soldered wire
7. Flashed firmware onconnect and other selections as noted in cleanflight.
8.Firmwarere flassuccessfully
9. Power cycled
10. No Joy- Port closed connection failed
I have looked throught the formaums and found no help. PLEASE HELP!
1. I am running windows 10
2. I have tried to load firmware via cleanflight and via a STM32 loader
3. I have purchased a new Naze32 rev 6 and as soon as I plugged it in, clean flight said I needed to update the firmware
4. I updated and power cycled
5. The board would not connect (port closed after a few seconds)
6. Connected boot pins via a soldered wire
7. Flashed firmware onconnect and other selections as noted in cleanflight.
8.Firmwarere flassuccessfully
9. Power cycled
10. No Joy- Port closed connection failed
I have looked throught the formaums and found no help. PLEASE HELP!