United7879
Member
Hello I’m new to building kits similar to the Flitetest builds. I’m currently building the mini mustang but am stuck on installing the prop. How stupid am I haha. So I put the spacer into the back of the prop and then turned the prop clockwise on the shaft. I’m stuck now because I can’t get the prop to move back to the smooth part of the shaft and there’s not enough thread to in the front part to put a nut or anything to tighten prop. Below is a picture of what my I’m looking at. After I fix that issue how do I put the cone looking spinner with 2 holes on the top on? Advice would be much appreciated!
Thank you!
Thank you!