RustySocket
Active member
So I have decided to get my feet wet in the 3D printing world and have an Anycubic i3 Mega on the way.
My primary intent is really just to learn with the added benefit of being able to make small parts for my models.
Any suggestions on filament choices and where to start?
EDIT: I ended up cancelling the order for the Anycubic and now have a Prusa MK3s. It is all set up and I am happily printing with it. In the end after doing a bit of research and the Anycubic not shipping due to the virus situation in China I realized that the Prusa was a better suited machine for what I intended to do.
The kit was a pleasure to build, it is well documented both online and with a printed manual. Prusa chat support has been easy to get a hold of and very helpful as well. The prusa was quite a bit over my initial budget but I believe in the end it was a good decision.
My primary intent is really just to learn with the added benefit of being able to make small parts for my models.
Any suggestions on filament choices and where to start?
EDIT: I ended up cancelling the order for the Anycubic and now have a Prusa MK3s. It is all set up and I am happily printing with it. In the end after doing a bit of research and the Anycubic not shipping due to the virus situation in China I realized that the Prusa was a better suited machine for what I intended to do.
The kit was a pleasure to build, it is well documented both online and with a printed manual. Prusa chat support has been easy to get a hold of and very helpful as well. The prusa was quite a bit over my initial budget but I believe in the end it was a good decision.
Last edited: