I have built many foamies but alway cut them out with a blade.
Decided that I will just buy a flerken millenium kit and was surprised to see the foam edges severely retracted under the paper. I assume that is because they were cut with laser and it melted the foam.
For most part it would not matter much but parts with sharp corners this poses a problem see pictures.
I tried to capture the best I can with my camera but it is difficult to get focus on the right parts.
Is this normal?
Decided that I will just buy a flerken millenium kit and was surprised to see the foam edges severely retracted under the paper. I assume that is because they were cut with laser and it melted the foam.
For most part it would not matter much but parts with sharp corners this poses a problem see pictures.
I tried to capture the best I can with my camera but it is difficult to get focus on the right parts.
Is this normal?