dodgebob
Junior Member
So I'm building my first plane . It's a simple cub . I am at the point where the servos get glued into the fuselage. I don't have a tx/ rx yet and I'm concerned about centering the servos. I don't have that slick little Gizmo to center them. I know where the servo is to be glued . Should I wait until I get my radio ? Should I glue them in and leave the screw loose to readjust it later? If you turn the servo end to end is the center point the center point? Do servos come from the factory placed in the center of the the throw?
So it's going to be a 3 channel plane to start . I'm worried that, without alirons it will not want to fly level. I have the b- power pack.i can easily mount the servos and cut the wing . I will be buying the radio in a couple of weeks . A dxe spectrum 4 channel I think what the man said . I have played on an airplane sim and to me it feels easier with the ailerons. What to do ???? 3 or 4 channel? Servo centering best practices???
Thanks everybody
Bob
So it's going to be a 3 channel plane to start . I'm worried that, without alirons it will not want to fly level. I have the b- power pack.i can easily mount the servos and cut the wing . I will be buying the radio in a couple of weeks . A dxe spectrum 4 channel I think what the man said . I have played on an airplane sim and to me it feels easier with the ailerons. What to do ???? 3 or 4 channel? Servo centering best practices???
Thanks everybody
Bob