New project = learning to design

[Andre]

So recently I picked up a SkyHunter 1800.

Decided I was going to need some customs 3D printed parts.
Fired up Fusion 360 and started learning.

I came up with a motor mount to support the FPV VTX and a spot for the pan and tilt camera.

https://www.thingiverse.com/andregt6/designs

The motor pods are not my work.

 

[Andre]

A little progress update on the SH18T.

I redid the FPV VTX mount, now I can set it up vertical or rotate it if I change antennas.
I had hoped to run it on 6S with 8X5 props but after doing some tests it is too much for the setup.
So back to 4S with 9x4.5 which I know is fine. This is the power setup from my FT SeaDuck which flew on rails.
In the future I'll invest in some 880kv motors which will allow me to run 6S.
I was just going for 6S since I have a healthy stock of them.

The initial flight will be flown on manually and then I will begin setup the F405 board.

 

[Andre]

 

[arnestion]

Amazing work, bro!