OWNERS MANUAL FOR SEARS/CRAFTSMAN SHAPER/ROUTER TABLE MODEL 572.530340

el rotundo

New member
Pulled this tool out of storage. It's probably 20-25 years old. Of course I don't have the manual anymore. I would really like to have one to verify that it's all there, and to give me instructions for proper setup and use. Sure hope there's some old fogeys out there that can give another old fogey a helping hand.
 

Bigcal26

New member
I can send a copy of the shaper/router owners manual
 

Attachments

  • 20210325_130315.jpg
    20210325_130315.jpg
    2.4 MB · Views: 0
  • 20210325_130304.jpg
    20210325_130304.jpg
    2 MB · Views: 0
  • 20210325_130257.jpg
    20210325_130257.jpg
    1.5 MB · Views: 0
  • 20210325_130238.jpg
    20210325_130238.jpg
    2 MB · Views: 0

hoshanaeckhart

New member
I found mine today, still in the boxes never put together. It was buried under a lot of other stuff in the shop. I got it mostly put together today. It's a Craig Jig brand, real heavy built. Now I gotta find the dang router. I looked it up online this afternoon. It cost over $700.00 today. I think it cost me in the neighborhood $250.00. best router for table mounting Needless to say, I am still cleaning up the dang shop. We did get her mom's stuff out there. I've still got a big pile of insulation laying in there. No backing on it. It's 8' wide, made to be put in a new steel building, as a matter of fact, it's leftover from building the new shop at the car dealership. I think I will cut it onto 15" wide batts and insulate the roof of the porch I enclosed last summer.
 
Last edited: