gorgeous.... hopefully it flies as well as it looks... what paint did you use?
On this, antrasit grey spraypaint, and the pure black is brushpainted enamel. (brushpaint do make it a bit heavier, but if are 20g in paint, or 40g isnt much to care about here anyway, the EDF should make 950g each...)
Wingtips curb is reinforced with "u-shaped" pushrod up at wingtip and into wing, pluss epoxyed. The wings placement was found by controlcheck on weights vs CG. Own hatch for battery, and own for rear servo + reciver eg. Wings are reinforced with 4mm caerbon rods fully out to wingtips.
Tailfins got square carbontube reinforcing all way down into belly. Canards just 3.17mm steelrod bendt to fit shape and bushings through fuselage sides.
Put on some small "fins" forward of wing(CG) and bulletshaped covers for servohorn under wing for bellylanding only.