Plans for multi rotor straight motor mount and landing gear

[Sewyboowy]

Hi. I was looking at the knuckle H-Quads and wanted to build one. I have the plans for the hub but there are no plans for the motor mounts and landing gear (or at least i haven't been able to find them). If they are up could someone point me in the right direction, or if not, if someone has made something similar, could they email it to me (sewart_t@bryanston.co.uk). I also sent a request but there was no reply. Thanks

 

[xuzme720]

http://www.stonekap.net/ftplans/Rotor Bones Straight 13-370 [0422].pdf

 

[Sewyboowy]

Thank you so much for replying so quickly.

 

[Sewyboowy]

Only one problem, these plans don't one of the pieces (the motor mount one). Does anyone know how thick the sheet of plastic should be?

 

[xuzme720]

I'm not sure why they dont have the mount on there, and I couldn't find the straight mount anywhere. Here is the tilt mount and you can use the actual mount profile combined with the single part from the other PDF to recreate the straight mount. They are using 1.5mm Delrin and 2.5mm G10, delrin for the landing gear portion and G10 for the mounts.

http://www.stonekap.net/ftplans/RB-Tilt Motor Mount Ver0450.pdf

 

[Sewyboowy]

Thanks