I wanted to share the plans for my current build.
Its a Spider Hex for FPV. The special thing about it. It uses 10° forward angled motors. I relay liked the idea from shrediquettes GEMiNi to improve the top speed of the quad by slightly angeling the motors forward.
http://shrediquette.blogspot.de/2013/03/wind-tunnel-test-data.html
I have a Blackout and i relay admire the construction so i tried to combine both ideas. Also i wanted to have universal parts (no special left-right arms or mounts). For this i had to angle the arms in just the right way. And also have a wired pattern in the arms.
Here are all the plans:
- A bill of material is still missing. I need to write that. Also some parts are not yet fully planed out.
http://www.thingiverse.com/thing:282606
It uses 40mm spaces between the top and middle plate. This also to mount bigger 38mm FPV Cameras. I also put mounting holes for a KK board in the middle plate.
Today (17.04.2014) i orders the plates (carbon-posten.de) and the mounts (shapeways).
For electrons i am going to use:
FC : Acro Naze32
ESC : Some 12-15A with SimonK
Motors : T-Motor MN1806 2300KV
Propeller: GemFan 5x3 2 Blade
Receiver : D4R-II
Live Cam : Sony Super HAD CCD 600TVL 2.8mm lens
HD Camera : GoPro3 Silver
Video Transmitter : Immersion RC 600mw
Antenna : Immersion RC SpiroNet v2
LiPo : Turnigy nano-tech A-SPEC G2 1800mah 3S 65C
This is my first custom build so i am sure i made some error. Some aspects i still have to figure out.
Its a Spider Hex for FPV. The special thing about it. It uses 10° forward angled motors. I relay liked the idea from shrediquettes GEMiNi to improve the top speed of the quad by slightly angeling the motors forward.
http://shrediquette.blogspot.de/2013/03/wind-tunnel-test-data.html
I have a Blackout and i relay admire the construction so i tried to combine both ideas. Also i wanted to have universal parts (no special left-right arms or mounts). For this i had to angle the arms in just the right way. And also have a wired pattern in the arms.
Here are all the plans:
- A bill of material is still missing. I need to write that. Also some parts are not yet fully planed out.
http://www.thingiverse.com/thing:282606
It uses 40mm spaces between the top and middle plate. This also to mount bigger 38mm FPV Cameras. I also put mounting holes for a KK board in the middle plate.
Today (17.04.2014) i orders the plates (carbon-posten.de) and the mounts (shapeways).
For electrons i am going to use:
FC : Acro Naze32
ESC : Some 12-15A with SimonK
Motors : T-Motor MN1806 2300KV
Propeller: GemFan 5x3 2 Blade
Receiver : D4R-II
Live Cam : Sony Super HAD CCD 600TVL 2.8mm lens
HD Camera : GoPro3 Silver
Video Transmitter : Immersion RC 600mw
Antenna : Immersion RC SpiroNet v2
LiPo : Turnigy nano-tech A-SPEC G2 1800mah 3S 65C
This is my first custom build so i am sure i made some error. Some aspects i still have to figure out.