pinpoint45
Pants Wearer
Hey didn't see a thread like this already, but i thought it might be fun!
Just post some pics or describe it, or both, detail any changes you made from the basic build.
So i decided to just E-Tape the ESCs on because i don't have a heat gun. I decided rather than soldering the VTX right to the board, i took a 1s connector from a bad E-Flight battery and solder that, that way if i'm flying near anyone else using FPV i can swap out a 200MW for a spektrum 11mw.
at the moment i only have 1 switch rigged to arm the quad, id like to set up another for horizon mode, but its been a while since i have messed with the DX6i and finding a switch setting as been a bit of a challenge.
this thread might just die after this post, but i think it would be cool to see what the community has done.
Just post some pics or describe it, or both, detail any changes you made from the basic build.
So i decided to just E-Tape the ESCs on because i don't have a heat gun. I decided rather than soldering the VTX right to the board, i took a 1s connector from a bad E-Flight battery and solder that, that way if i'm flying near anyone else using FPV i can swap out a 200MW for a spektrum 11mw.
at the moment i only have 1 switch rigged to arm the quad, id like to set up another for horizon mode, but its been a while since i have messed with the DX6i and finding a switch setting as been a bit of a challenge.
this thread might just die after this post, but i think it would be cool to see what the community has done.
