Hi I am setting up a kk2.1.5 on my hex rotor.
Turnigy 9x transmitter and receiver
stock kk2.1.5 from hobbyking
stock turnigy plush 30amp esc
multistar 2213-935 motors
The problem I'm having is that no matter what I do I cant get the throttle to zero in the receiver test, the lowest it goes is 15. when I push down on the stick it goes to zero and says idle but when i push up the highest i could get it to go is about 60 no matter what i did to the subtrim. I am assuming thats why it wont arm because the throttle is at 15 not zero. also when I try to calibrate my escs i hold down buttons one and four and it enters the calibration mode the escs just constantly beep. they dont beep once so I can then move my stick down they just keep beeping and I have no way to calibrate them.
If anyone has any suggestions that would be great.
Turnigy 9x transmitter and receiver
stock kk2.1.5 from hobbyking
stock turnigy plush 30amp esc
multistar 2213-935 motors
The problem I'm having is that no matter what I do I cant get the throttle to zero in the receiver test, the lowest it goes is 15. when I push down on the stick it goes to zero and says idle but when i push up the highest i could get it to go is about 60 no matter what i did to the subtrim. I am assuming thats why it wont arm because the throttle is at 15 not zero. also when I try to calibrate my escs i hold down buttons one and four and it enters the calibration mode the escs just constantly beep. they dont beep once so I can then move my stick down they just keep beeping and I have no way to calibrate them.
If anyone has any suggestions that would be great.
