clouddancer
Junior Member
Im having trouble getting plans printed correctly .
Specifically the ft 3d and the baby blender.
I emailed plans to Office Max, and after they couldnt determine what settings were neeeded for the size.
I told them it should fit within a 20in x 30in length and width. After three attempts with the ft3d, the page 2 seemed right.
The fire wall was 2in.wide and canopy part was 2in. wide and the wings were just under 15 in.each
Page 1 was way off, the fusalage was1and1/4 wide and way to short. They charge $9.00 per print and after 4 trys, i stil dont have workable plans.
Any help here on how you guys get these plans printed would be much appreciated. Specifically what settings could i tell them to use that will print these plans correctly.
Thanks, Scott
Specifically the ft 3d and the baby blender.
I emailed plans to Office Max, and after they couldnt determine what settings were neeeded for the size.
I told them it should fit within a 20in x 30in length and width. After three attempts with the ft3d, the page 2 seemed right.
The fire wall was 2in.wide and canopy part was 2in. wide and the wings were just under 15 in.each
Page 1 was way off, the fusalage was1and1/4 wide and way to short. They charge $9.00 per print and after 4 trys, i stil dont have workable plans.
Any help here on how you guys get these plans printed would be much appreciated. Specifically what settings could i tell them to use that will print these plans correctly.
Thanks, Scott