Q-Tee 250 by Willy Nillies

Willy Nillies

Elite member

Attachments

  • IMG_20200429_165730059.jpg
    IMG_20200429_165730059.jpg
    3.5 MB · Views: 0
  • IMG_20200426_211912792.jpg
    IMG_20200426_211912792.jpg
    2.6 MB · Views: 0
  • IMG_20200510_204715464.jpg
    IMG_20200510_204715464.jpg
    4.1 MB · Views: 0

Turbojoe

Elite member
If I wasn't almost ready to start covering my original Q-Tee I'd order a kit but at the snails pace I'm progressing the biplane will probably be ready for release when I finally finish. I'll grab one of the biplane kits then.

Joe
 

TooJung2Die

Master member
That is such a cool looking airplane. I'd have to resurrect one of the old Cox .049 for that baby. It would be worth the trouble just to hear that sound again.
 

speedbirdted

Legendary member
Q-Tee 250 beta kits pre-order now available. Kits will start shipping no later than May 18th, 2020.

https://willynillies.com/shop?olsPa...-classic-trainer-beta-kits-limited-quantities

Please let us know if you have any questions.

Sincerely
Doug and Becky
WillyNillies.com
Great! I saw on the FB group you had some interest in making 020 throttle sleeves. I think one would work perfectly on this. I have one total for the many 020s I have lying around on and off airplanes, except it doesn't seal very well so the actual throttling ability of it is pretty limited. Certainly doesn't idle low enough to land. A better fitting one would be wonderful.
 

Motobiman

Member
I have a few block planes but it's for certain I'd completely destroy several very long (and expensive) sections of usable balsa in the planing process. I'll just wait until I can buy what I actually need. While I'm waiting the Willy Nillies Q-Tee will likely have been released. I still think I'll wait for the biplane version however long it takes. I like bipes. I have way too many high wing, shoulder wing and low planes. I have way too few biplanes.........

Joe
I cut it off thick sheet in the table saw.
With a decent blade it only needs a quick sand.