Sasikanth T
New member
Hi. I'm a beginner and this is my first activity in this forum. And this is my first ever RC build.
I made a quadcopter using:
APM 2.8 flight controller,
10x4.5 props,
1400KV BLDC,
simonK 30 amps ESC,
ublox neo 7m GPS with compass.
And the radio system is flysky ct6b. Everything probably an entry level component.
MY ISSUE IS, WHEN I PUSH THE THROTTLE UP, ONE MOTOR STARTS SPINNING, WHEN I INCREASE THROTTLE A BIT MORE, ANOTHER MOTOR STARTS SPINNING AND IN THE SAME WAY WHEN I GIVE ABOUT 40 - 50 % THROTTLE ALL START SPINNING. SO ALL MOTORS DON'T SPIN AT THE SAME TIME AT THE SAME THROTTLE LEVEL. My entire system is fully calibrated and sensors are also set perfectly. All of this is done in APM Mission Planner. This is my only issue.
Please help me with this issue.
I made a quadcopter using:
APM 2.8 flight controller,
10x4.5 props,
1400KV BLDC,
simonK 30 amps ESC,
ublox neo 7m GPS with compass.
And the radio system is flysky ct6b. Everything probably an entry level component.
MY ISSUE IS, WHEN I PUSH THE THROTTLE UP, ONE MOTOR STARTS SPINNING, WHEN I INCREASE THROTTLE A BIT MORE, ANOTHER MOTOR STARTS SPINNING AND IN THE SAME WAY WHEN I GIVE ABOUT 40 - 50 % THROTTLE ALL START SPINNING. SO ALL MOTORS DON'T SPIN AT THE SAME TIME AT THE SAME THROTTLE LEVEL. My entire system is fully calibrated and sensors are also set perfectly. All of this is done in APM Mission Planner. This is my only issue.
Please help me with this issue.