RCTimer KK board

[Miniprinter96]

http://www.rctimer.com/index.php?gOo=goods_details.dwt&goodsid=725&productname= ~ I found this KK board from RCTimer.com. Does anybody have experience with this board? I looks similar to other boards I've seen, and it's only $19 with the programming cable. There seem to be a lot of similar ones on eBay. I've ordered from RCTimer before, and they seem to have quality products.

 

[Tritium]

The KK 5.5 is a good board and I have one just like pictured. That is a good price delivered too. The only thing I like better about the hobby king board is the input pin spacing but that is not an issue since the board pictured comes with cables.

Thurmond

 

[Miniprinter96]

What's the difference in the input pin spacing? Where are the input pins on the board?

 

[Tritium]

The pins for each plug (Ailerons, Elevator, Throttle, Rudder) fit a standard plug but on the particular board you show they are farther apart than .1" normal pin spacing. The HK board is .1" pin spacing in both directions. Like I said since the cables are included it is a non issue and if you use 4 input cables it is a non issue as well. It is only an issue if you wanted to use the 2 cable trick (First cable normally installed and next cable on signal pins only cross ways).

Thurmond