Receiver advice?

[Brian fred carr]

Hi chaps
I have most of the set up to build a 3d foamie but the stock receiver you get with the 9x is way
too big, so does anyone know of micro receivers that are compatible
look forward to getting loads of suggests......keep flying

 

[colorex]

Here's one, but it's only 3 ch:

http://www.youtube.com/watch?v=9pgfRykX9dU

Here's a thread from an awesome forum:

http://flitetest.com/forum/showthread.php?666-Micro-receivers-compatible-with-Turnigy-9X

Here's something else:

http://www.wifly.co.za/boards/t/84/turnigy-9x-receiver-options.aspx

Hope that gets you started, it looks like you have the most possibilities if you switch the module out.

 

[Klonas]

As colorex mentioned a 3channel one in hobbyking:
http://www.hobbyking.com/hobbyking/store/__10625__Hobby_King_GT_2_2_4Ghz_Receiver_3Ch_.html

But I guess you want 4 channels on a 3d plane. There is a 6ch receiver compatible with Turnigy 9x. It's smaller than the original one but is it small enough?
http://www.hobbyking.com/hobbyking/store/__12901__Hobby_King_2_4Ghz_Receiver_6Ch_V2.html

 

[ananas1301]

Does it not help getting rid of a few grams by just using the guts of the receiver?!

It is kind of an compromise you gotta do coz then all the receiver electronics are open for everything --> heat shrink