SAFE on DX6i

[silbo99]

Hello guys,

Yesterday I bought the HobbyZone F4U Corsair S (looks awesome) and I bound it to my DX6i. However, I dont know how SAFE works on the DX6i. The guys at the hobbyshop where I bought the plane said that it was perfectly possible to use SAFE on my DX6i, but there is no 3-modes switch. Is the trainer switch the Oh crap switch (panic switch)?

I have a DX4e as well, but my DX6i is so much nicer....

thanks,
Silvester

 

[meatay]

I have an Apprentice which uses the same technology. Check out page 23 of the Apprentice manual: http://www.e-fliterc.com/ProdInfo/Files/EFL3100-Manual_EN.pdf


• SAFE Flight mode is selected using Channel 5 signal (high, middle, low)
• Panic mode is selected with Channel 6 signal (high, low)




It recommends diving into the setup screens and setting
Panic mode = to your flaps switch (i.e. flaps switch = channel 6)
and
Safe mode selection = to your "gear" switch on the upper left hand side (i.e. gear switch = channel 5)

Hope that helps.