I have an issue with servo jitter
I am using Emax ES08 servos with an Orange R615X receiver on a 4ch plane (FT Simple Cub) as a three Chanel plane ie Rudder Elevator and throttle all works fine no jitters. As soon as I add the ailerons one in the aileron port and the other in Aux the initial setup is OK but after a few inputs into the aileron all hell beaks lose with all servos jitering and the motor cuts out. I have swapped over the servos but same result. This also happens when the transmitter is off. Any ideas ??
I have read the other post but they seem slightly different as to what happens to my model.
I am using Emax ES08 servos with an Orange R615X receiver on a 4ch plane (FT Simple Cub) as a three Chanel plane ie Rudder Elevator and throttle all works fine no jitters. As soon as I add the ailerons one in the aileron port and the other in Aux the initial setup is OK but after a few inputs into the aileron all hell beaks lose with all servos jitering and the motor cuts out. I have swapped over the servos but same result. This also happens when the transmitter is off. Any ideas ??
I have read the other post but they seem slightly different as to what happens to my model.