so i was just bench testing a wing i built and after a few minutes of moving the servos i noticed that they started showing delayed reaction time, soon after that they started lagging and jittering, moments later the motor ran at full throttle and i didn't touch throttle through out the entire test! the prop was on and was just a few cm from me! luckily it didn't hit me....
I've got no idea why this happened but i'm guessing it might be my radios fault...
Nothing seems to be overheating, all the electronics are running quite cool and i don't think its interference from the esc and sbec because i moved the receiver well away from them and still went through the same scenario
Another thing i noticed was that when i move my right stick down and left (i fly mode 2) all the servos start jittering and even the motor speed starts to change too in a pulse like manner
Any idea what might be the problem? Is it my radio going bad or some other thing that's causing this?
Thanx in advanced!
I've got no idea why this happened but i'm guessing it might be my radios fault...
Nothing seems to be overheating, all the electronics are running quite cool and i don't think its interference from the esc and sbec because i moved the receiver well away from them and still went through the same scenario
Another thing i noticed was that when i move my right stick down and left (i fly mode 2) all the servos start jittering and even the motor speed starts to change too in a pulse like manner
Any idea what might be the problem? Is it my radio going bad or some other thing that's causing this?
Thanx in advanced!