DirectGumby
Junior Member
Hello all,
I have an interesting issue where i'd like to use the gimbal mode, but ONLY for the pitch. I have read through sever areas where folks turn on the servo gimbal mode but that moves the four motor controls to slots 3,4,5, and 6. Currently 6 is connected to the OSD on the power and ground. I could power the system differently but real all I want to do is control the single axis tilt from one of the ports.
Two things are on my mind here:
1) Setting up ctrl 5 as a servo control and then map a transmitter channel to change the tilt or
2) setup the servo gimbal mode to only care about the pitch
Any thoughts on how I would do either, and/or any other suggestions?
Thanks.
I have an interesting issue where i'd like to use the gimbal mode, but ONLY for the pitch. I have read through sever areas where folks turn on the servo gimbal mode but that moves the four motor controls to slots 3,4,5, and 6. Currently 6 is connected to the OSD on the power and ground. I could power the system differently but real all I want to do is control the single axis tilt from one of the ports.
Two things are on my mind here:
1) Setting up ctrl 5 as a servo control and then map a transmitter channel to change the tilt or
2) setup the servo gimbal mode to only care about the pitch
Any thoughts on how I would do either, and/or any other suggestions?
Thanks.