bikerman124
Member
I just bought an Atom V3 kit build. I thought my hobby flying days were over because it was getting too expensive, but then I saw that the Atom V3 which I had been watching about 2-3 years ago when it first came out on FT's store, had a major price cut. So I bought it.
Now I have assembled the copter, and now I'm trying to figure out how to get things programmed in beta flight. TJ's instructional video is only helpful if you have the exact same controller and receiver. In order to make the case of the copter fit, I broke off the extra pins that I didn't need on the AR400 receiver and directly soldered the correct lines to each other. My questions are, what settings do I need to have in beta flight to allow the quad to function and how do I program the individual channels (throttle, pitch, yaw, etc) into the controller. I do not have any response from the controller to the quad but the bind light on the controller is properly lit.
I would like to avoid having to buy a new transmitter and receiver as a new transmitter would be more than the price of the quad.
Now I have assembled the copter, and now I'm trying to figure out how to get things programmed in beta flight. TJ's instructional video is only helpful if you have the exact same controller and receiver. In order to make the case of the copter fit, I broke off the extra pins that I didn't need on the AR400 receiver and directly soldered the correct lines to each other. My questions are, what settings do I need to have in beta flight to allow the quad to function and how do I program the individual channels (throttle, pitch, yaw, etc) into the controller. I do not have any response from the controller to the quad but the bind light on the controller is properly lit.
I would like to avoid having to buy a new transmitter and receiver as a new transmitter would be more than the price of the quad.