Stevens Aeromodel Cap 232

[chris398mx]

Thanks! I used a razor blade and scraped across where the two pieces of covering overlapped. Once I got a little bit of an edge peeling up, it's just a matter of slow pressure to get them to separate, and again to separate the bottom covering layer from the balsa. Since I had about 3/8" overlap on the covering it was plenty to get it to adhere back in place. I'll post up a picture of the finished repair later tonight.

Great, thanks. No heat required to soften the adhesive? (I know this would be tricky given that much heat would want to shrink the covering.

 

[rockyboy]

Great, thanks. No heat required to soften the adhesive? (I know this would be tricky given that much heat would want to shrink the covering.

No heat needed in this case, but that might have made it even easier if I put the iron to it as I pulled!