Hay guys I'm priety new to foam and electrics in general but I'm concerned at how hot the esc and motor are getting in my storch. I'm running a 2200kv outrunner with a 30a esc and a 2200mh 3cell swinging the 10x4 slow fly. I just flew for about 5 min to trim it out and get it ready for a buddy box to teach my kid. I have the throttle set to 50% max on my remote (that's how i run my sig Riser 78 full power on it is way to much and I just forgot to change it) any way after 5 min I landed and the esc had melted the hot glue holding it to the power pod and the motor was to hot to touch for more then a few seconds. Is this normal or an I missing somthing ? Thanks all for the help