Maingear
Flugzeug Liebhaber
Here's what I got......
Suppo 30A esc
BL-2217-7 motor
7.4V 5000mAh 50C 2C charge rate lectron pro batt.
Only hooked esc to motor and into RX.
Throttle up, get one beep, drop throttle after first beep to set for lipo batt. Get conformation beep.
Reconnect batt then motor runs for three seconds then nothing.
I've read about setting an esc to the RX, no documentation in suppo setup about changing pins. Using a sprektrum dx6 and the RX that came with it (the one that was realized in June 2014)
Any suggestions?
Justin
Suppo 30A esc
BL-2217-7 motor
7.4V 5000mAh 50C 2C charge rate lectron pro batt.
Only hooked esc to motor and into RX.
Throttle up, get one beep, drop throttle after first beep to set for lipo batt. Get conformation beep.
Reconnect batt then motor runs for three seconds then nothing.
I've read about setting an esc to the RX, no documentation in suppo setup about changing pins. Using a sprektrum dx6 and the RX that came with it (the one that was realized in June 2014)
Any suggestions?
Justin
Last edited: