Hello all, first post at this forum so let´s see how it goes.
I was intrigued by the swappable series and have completed to build the FT flyer. The weather in Sweden right now is to windy to fly so I though I should make a proposal of a trainer build on the same platform.
So here is my first idea and a sketch for the trainer version of the swappable series. I have use the FT-flyer rear fuselage and cut down the fin 20mm. This way can I use old drawings and only add a new wing.
First question would this fly?
Second question would it fly good?
I am no pro in CAD tools or airplane construction. I have search for a fundamental guide for airplane construction like size of wing vs. elevation and measurement between etc. There is a few measurements that seam holy when you design a scratch plane but I have not found any good information regarding this.
I was intrigued by the swappable series and have completed to build the FT flyer. The weather in Sweden right now is to windy to fly so I though I should make a proposal of a trainer build on the same platform.
So here is my first idea and a sketch for the trainer version of the swappable series. I have use the FT-flyer rear fuselage and cut down the fin 20mm. This way can I use old drawings and only add a new wing.
First question would this fly?
Second question would it fly good?
I am no pro in CAD tools or airplane construction. I have search for a fundamental guide for airplane construction like size of wing vs. elevation and measurement between etc. There is a few measurements that seam holy when you design a scratch plane but I have not found any good information regarding this.