SxR Setup (S6R, S8R)

sanpol

New member
Dear Friend. Thank you so much for such a great material.
I have a suggestion about setting the Knob Gain control for receivers S6R and S8R.
Wright now, there is a link to a video sent by Painless360, but it just shows how to create curves at the Open Tx.
He made another video specially about S6R, that shows exactly how to set the knob gain curve used on channel 9 , and I think would be great if you could add the link and the time of the video the setting appears ( 11:25 )to the post you made.
The link for his video is :
The name of the video is : (1/2) Frsky S6R/S8R Basic Setup
The time that the setting appears at the video is : 11:25

Kind regards :)
 

Buffalo Man

New member
The SxR (S6R & S8R) receivers provide stabilization, level, knife edge and hover flight modes.


Setup instructions and tips for the SxR have been gathered from a number of different sources and put in a blog post.




Check out the blog post and video.
https://youtu.be/XIe9nsuOJtU
http://rcdiy.ca/sxr-setup-s6r-s8r/


Stay Safe & Have Fun
The SxR (S6R & S8R) receivers provide stabilization, level, knife edge and hover flight modes.


Setup instructions and tips for the SxR have been gathered from a number of different sources and put in a blog post.




Check out the blog post and video.
https://youtu.be/XIe9nsuOJtU
http://rcdiy.ca/sxr-setup-s6r-s8r/


Stay Safe & Have Fun
With my no-longer new but never used S8R with the STK tool, I've been struggling with a steady yellow LED during the accelerometer calibration process. Everything (including update) seems fine until I'm at the third step in calibration where the yellow light goes to steady while the red continues to flash normally, and it wont allow any further input to finish the calibrate procedure. Anybody see this before?