Quarantined here in the UK so dug out what supplies I had:
- One sheet of flitetest brown foam, 2/3rds of a board of white foam.
- Emax 2205 2600kv motor
- 6x5 bullnose wood prop or 7x3 APC thin electric
- Emax 20g digital servos x3
- 1300mah 3s
- 30a Turnigy plush ESC
- A few carbon rods
- Lemon rx
- Some wheels off a 200% Racer
- Blue pearlescent paint
I have loosely based this build on the Tigermoth, with larger control surfaces optimised for 3D aerobatics. I have looked at a few photos and cut this out freehand, very little measurements and no drawings, just some Covid creativeness!
Got to laugh at them wheels!
Carbon rods push the elevator, rudder and rear wheel steering.
You get the idea.
I should have the canopy and upper wing finished this week. Will give it a paint and report back.
This is how I've been annoying my better half:
Hope your all staying safe and making good use of the time. 🤣