Guy S.
Well-known member
When programming the tool paths, do most people run the tool centerline on all cuts, or do you offset the cutter radius?
I’m looking at some of the Flite Test plans, and things seem to be a all over the place dimension wise. All the score cuts for A and B folds seem to really vary and I’m not sure what the intention of the designer was. Or as a machinist, am I really over thinking this?
I’m looking at some of the Flite Test plans, and things seem to be a all over the place dimension wise. All the score cuts for A and B folds seem to really vary and I’m not sure what the intention of the designer was. Or as a machinist, am I really over thinking this?