tomiodaumit
Junior Member
Hey guys,
I am new to FPV, this is actually my first build. My tricoper is built from Davis' platform with the following setup:
Hobbyking 20A ESC's
Turnigy D2830 1000kv motors
i86 control boardDigital servo
Turnigy 9X Transmitter
So I finished the build, and was ready to link everything up, then the clicking started. After plugging the battery in the control board light just flashes red and the servo starts to make a low clicking noise. The switches on the control board are set to the positions for the tricopter setting, and I try to link it to my transmitter, but nothing happens. Perhaps I missed a big step in setting it up, like I said, I'm a total novice and don't know what I am doing, but I could use some help.
How to I link the transmitter to the copter, and is the clicking noise from the servo normal?
Thanks guys!
Tomio
I am new to FPV, this is actually my first build. My tricoper is built from Davis' platform with the following setup:
Hobbyking 20A ESC's
Turnigy D2830 1000kv motors
i86 control boardDigital servo
Turnigy 9X Transmitter
So I finished the build, and was ready to link everything up, then the clicking started. After plugging the battery in the control board light just flashes red and the servo starts to make a low clicking noise. The switches on the control board are set to the positions for the tricopter setting, and I try to link it to my transmitter, but nothing happens. Perhaps I missed a big step in setting it up, like I said, I'm a total novice and don't know what I am doing, but I could use some help.
How to I link the transmitter to the copter, and is the clicking noise from the servo normal?
Thanks guys!
Tomio