Hi everyone,
I recently purchased a Red Brick 50A ESC (Heli Mode) but it acts very strange. At first you increase the throttle there is no power, even at full throttle. I programmed the ESC for hard acceleration, but no improvement.
The other big problem is that the ESC re-initializes after I applied throttle, see the video I made below, and note what happens at the end after I kill the throttle.
Any advice please. I went through the whole programming sequence (The instructions that came with the ESC is wrong, you can use this manual as it matches the beeps) and it still does the same.
http://www.hobbyking.com/hobbyking/store/uploads/794090796X32857X50.pdf
Thanks
Arno
I recently purchased a Red Brick 50A ESC (Heli Mode) but it acts very strange. At first you increase the throttle there is no power, even at full throttle. I programmed the ESC for hard acceleration, but no improvement.
The other big problem is that the ESC re-initializes after I applied throttle, see the video I made below, and note what happens at the end after I kill the throttle.
Any advice please. I went through the whole programming sequence (The instructions that came with the ESC is wrong, you can use this manual as it matches the beeps) and it still does the same.
http://www.hobbyking.com/hobbyking/store/uploads/794090796X32857X50.pdf
Thanks
Arno