randyrls
Randy
This may not be the correct forum for this, but I couldn't decide where else to post it.
I am working on a twin sparrow. I got the SBK and the power pack H twin. I followed along with the video and wired the power distribution (PD) , esc, and motors. I wanted to test the motor(s) direction. This is noticeably missing from the video. I plugged the servo tester into the black/white wire pair, and battery balance lead to the Servo tester. I smoked the PD when i plugged it into the JST battery connection 3S 480mah. ??!!
Is this not a valid setup? I have used the servo tester to test other esc's with built in BECs.
I am a former Navy Electronics Tech. So I'm sure the polarities are correct and no solder bridges.
I am working on a twin sparrow. I got the SBK and the power pack H twin. I followed along with the video and wired the power distribution (PD) , esc, and motors. I wanted to test the motor(s) direction. This is noticeably missing from the video. I plugged the servo tester into the black/white wire pair, and battery balance lead to the Servo tester. I smoked the PD when i plugged it into the JST battery connection 3S 480mah. ??!!
Is this not a valid setup? I have used the servo tester to test other esc's with built in BECs.
I am a former Navy Electronics Tech. So I'm sure the polarities are correct and no solder bridges.