So I got the Orangerx openlrs 100mw rx and module a few weeks back. I uploaded the openlrsng firmware sucessfully. They worked perfectly for about 10 flights, until randomly they just stopped communicating. I had no servo control and every time I would plug the battery in the servos would start overheating. It was just really weird. So I grudgingly bought another rx and module, since the flytron openlrs wasn't in stock and I can't afford any other UHF system. Once again I downloaded the firmware and It was working fine until I encountered a lockout about 100m out in a semi-urban environment that just about destroyed my whole plane. After I fixed it I went to fly again in the same spot to see if it was interference that caused the lockout. I ground tested it about 500m and everything worked fine. However, when I flew I could only get 75m tops before I got locked out. I tried a new location. This one was a bit more isolated and I got maybe 200m no problems (that's the farthest I flew). So could interference be locking me out at the more urban place? It is strange because I had never been locked out before even in the same spot. Other than that I would highly recommend avoiding orangerx openlrs because is is just so unreliable. I think rc equipment hates me. I never have consistent success, and I can never fully diagnose my problems.