Just built my Versacopter. Have Graupner GR-18 receiver and MZ-12 Rx combo. Bind was successful. Calibrated ESCs ok and calibraged the Gyros also. However, when tried to fly today, normal beeps when binding happened then continuous beeps and no further response from Versacopter. Is it an alarm? What could be the reason. All wiring looks ok. Any ideas? Would appreciate comments, ideas, any help. Thanks.
Versacopter Issue - Bound, but continuous beep when try to Launch
- Thread starter andison
- Start date
The Alpine Ace
New member
I agree, seems like a low voltage alarm
if it's an old battery, consider replacing it, if not... balance charge it.
if it's an old battery, consider replacing it, if not... balance charge it.
