One would think. I love being cheap, but sometimes being cheap can be expensive.
I got in a rush, and bought some budget motors that I knew would ship to me fast.
It caused a crash of my quad yesterday. No matter what I have tried, I can't seem to eliminate the high end vibrations from my motors. I did the zip tie trick, added tape, balanced and rebalanced my props, and for some reason they just won't stop vibrating at higher RPMs.
Then I took it apart to try to balance it another way, and this is what I found....
There's a giant puddle of epoxy inside the bell. There's a few globs in other places, but this one's the worst.
It will make balancing my motor almost impossible. I can only assume that all four are the same way.
I'll spend the extra couple dollars per motor, to make sure I get one that's got a little better quality control from now on.
I got in a rush, and bought some budget motors that I knew would ship to me fast.
It caused a crash of my quad yesterday. No matter what I have tried, I can't seem to eliminate the high end vibrations from my motors. I did the zip tie trick, added tape, balanced and rebalanced my props, and for some reason they just won't stop vibrating at higher RPMs.
Then I took it apart to try to balance it another way, and this is what I found....
There's a giant puddle of epoxy inside the bell. There's a few globs in other places, but this one's the worst.
It will make balancing my motor almost impossible. I can only assume that all four are the same way.
I'll spend the extra couple dollars per motor, to make sure I get one that's got a little better quality control from now on.