X9d servo travel issue

[Pilot_35]

How do I adjust the servo travel in my x9d? I checked the box that said extended limits and tried adjusting the servo travel through the mixer page and inputs (I think it is called the inputs page. I believe it’s page 7) page. None of these have done anything to the servo. I know the servo can go further. What I am I doing wrong?
Thanks

 

[ElectriSean]

Servo travel and subtrim is set up in the outputs page.

 

[Pilot_35]

I have tried adjusting the max and minimum on the outputs page and it still not doing it. And I have double checked I am on the right channel.

 

[ElectriSean]

If you've made sure that all of your weight settings are at 100 and have gone to the limits of the servo travel in the radio all you can do is adjust things mechanically to get more throw. Use the outermost hole in the servo horn and the inner most hole on the control horn to get the maximum throw.

 

[Pilot_35]

When I try and adjust the throw it does not seem likes it’s doing anything. I know the servo can move father but I can’t figure out how to tell it to move father.