NoahComprende
New member
When I was soldering up the board for the Gremlin, one of the "boot" pads, the 3 V solder pad delivering power to the receiver, came off of the board. Is there any way around this problem or do I need to buy a new board? Does the other "boot" pad deliver 3 V also? Could I solder the receiver wire to the corresponding location on the under side of the board, or is that a separate circuit?
I had everything soldered up correctly but was having trouble getting the transmitter / receiver to register correctly in betaflight. When I was double checking all of the connections, the receiver wire and 3 V boot pad pulled off.
Thanks for the help.
I had everything soldered up correctly but was having trouble getting the transmitter / receiver to register correctly in betaflight. When I was double checking all of the connections, the receiver wire and 3 V boot pad pulled off.
Thanks for the help.