Help please

[Mattg 40]

Hi therr, can someone please help me? I have a tbs power cube and a flysky fs-i6 with a fs-iA6b receiver. Im struggling to get any inputs on beta flight or clean flight, i had them before but messed up my board, i got a new one and no i only get the arm signal comming through. I only seam to get power to the receiver when the battery is connected. Ive attached some pics so you can see what im working with, its all connected using ppm. Im new to this and struggling, can anyone help? Ive watched loads of youtube videos but cant seam to figure it out. Thanks Matt

 

[PsyBorg]

You have uart 1 set to msp when it should be set to serial rx if that is the port specified for your receiver. Set uart 1 to serial rx and save the page then you have to go to the configuration page and re select the correct receiver and protocol then save that page.

If you dont save the page before going to a new one the changes revert back to what they were. As for power to the receiver some boards do not power them thru the usb port so that can be a normal situation.

 

[Mattg 40]

Thank you, i will give that ago