scout xl

First shot at making 3D models and not sure why the STL files are not exactly the same size (KB). They're the same just mirrored the exhaust. Not too bad but the thru-holes for the BBQ skewers are a little bit big. not a friction fit. Also new at 3D printing and have not yet figured out the...

Dummy Radial XL for FT 2814 Designed By: Dan Sponholz This dummy radial engine is designed to work with the Flite Test 2814/1100kv motor. I designed it to add semi-scale detail to your foam board model airplanes. It prints as a single piece with no supports using basic PLA filament. The dummy...

FT Scout XL Elevator Support and Control Horn This replaces the Popsicle stick on the elevator, plus adds the control horn. It can be printed flat in PLA or PETG with no supports. Be careful not to use to much hot glue with PLA so as not to melt and deform it as you are installing. It can...

FT Simple Scout XL Gear Plate STL Designed By: Dan Sponholz 3D printed gear mounting plate for use with the FT Simple Scout XL. This plate is designed to be used as a reinforcement for the foam board landing gear tab on the Scout XL. Assembly is similar to the FT Tutor landing gear. Reference...

FT Simple Scout XL Firewall STL Designed By: Dan Sponholz 3D printed firewall for use with the FT Simple Scout XL. This firewall is designed to be used with the FT 2814-1100kv motor. It will also support any motor with a 19mm x 25mm bolt circle for direct mount, or 44mm X-mount bolt circle...