3dprint

Started (almost finished) this CAD model of a balsa Motorglider with 3D printed PLA wingribs & Fuselage. It'll be very fun and interesting to combine new & old techniques. Wingspan: 2300mm (90.55") Length: 1365mm (53.74") Motor: Aerostar 800kv ESC: Aerostar 60amp Battery: 2200mAH 4s I'm...

Dummy Radial 9 Cylinder Engine STL Designed By: Dan Sponholz This dummy radial engine is designed to work with the Flite Test Power Pack B/C Pack Radial motors. I designed it to add semi-scale detail to your foam board model airplanes. It prints as a single piece with no supports using basic...

I have one of these bevel cutters and it works really well. I've never really liked A and B folds so for my next plane (a pusher Hangar Simple Stick with FPV) I thought I would just cut bevels for the square profile body and fold it up. It sure was quicker and easier to build. Has anyone else...

Hey everyone. This has been a semi-secret project in the works for a couple months now. It's a long read, so skip to the end if you just want to see the finished product. Some of you may know of my DIY 2-axis gimbal builds that I have done using wood and acrylic in the past. Well, back in...

the cowls are for 90mm fans and each it rotated by a micro servo in the "wrist". the tail is also set up to put a servo for rudder movement. the fuselage can hold a 6S lipo along with a kk2 and a gimbal in the nose. the hole for the dome is 3in. if anyone has any better ideas please comment and...